Reproductive tract disease in Irish grazing dairy cows: Retrospective observational study examining its association with reproductive performance and accuracy of 2 diagnostic tests

The detection of reproductive tract disease (RTD) 3 wk postpartum is important because of its effect on subsequent reproductive outcomes. Numerous methods for the diagnosis of RTD are described, some of which are more practical and instantaneous in terms of diagnosis. Two of these methods involve identification of purulent vaginal discharge (PVD) and evidence of ultrasonographic uterine changes indicative of endometritis (UE). The objectives of our retrospective observational study were (1) to assess the association of PVD or UE score at the prebreeding examination (PBE) with the hazard of pregnancy within the subsequent breeding season; (2) to determine the test sensitivity (Se) and specificity (Sp) at the point of sampling of both tests using a Bayesian latent class model; and (3) to determine the effect of varying positivity thresholds on test accuracy. To achieve these objectives, we analyzed an initial data set of 5,049 PBE from 2,460 spring-calved cows in 8 herds between 2014 and 2018. Each PBE was conducted once between 25 and 86 d in milk. At each PBE, vaginal discharge was obtained with a Metricheck device (Simcro) whereas uterine contents were assessed using transrectal ultrasonography. Purulent vaginal discharge was scored on a scale of 0 to 3 depending on discharge character, and UE was scored on a scale of 0 to 4 depending on the presence and consistency of intraluminal fluid. Cows with scores of ≥2 in either test had received treatment. Fertility data were available from 4,756 PBE after data exclusion. The association between PVD or UE score at the PBE and subsequent hazard of pregnancy was analyzed using a Cox proportional hazards model. Cows with a PVD score of 2 or 3 were less likely to conceive than cows with a PVD score 0 [score 2 hazard ratio (HR) = 0.74; 95% confidence interval (CI): 0.59–0.94; score 3 HR = 0.65; 95% CI: 0.51–0.84]. Cows with a UE score of 1, 2, 3, or 4 were less likely to conceive than cows with a UE score of 0 (score 1 HR = 0.82; 95% CI: 0.73–0.93; score 2 HR = 0.79; 95% CI: 0.62–1.00; score 3 HR = 0.43; 95% CI: 0.43–0.90; score 4 HR = 0.39; 95% CI: 0.26–0.58). To determine the Se and Sp of PVD or UE score for diagnosis of RTD at the time of PBE, a Bayesian latent class model was fitted on 2,460 individual cow PBE. Flat priors were used for the Se and Sp of UE, whereas informative priors were used for PVD Se (mode = 65%, 5th percentile = 45%) and Sp (mode = 90%, 5th percentile = 80%) and RTD prevalence (mode = 20%, 5th percentile = 10%). Posterior estimates (median and 95% Bayesian probability intervals; BPI) were obtained using ‘rjags' (R Studio). The optimal test thresholds (PVD and UE score ≥1) were selected by assessing the effect of different thresholds on test estimates and using a misclassification cost analysis. Based on these, median (95% BPI) Se for PVD and UE score ≥1 were 44% (29–60%) and 67% (33–100%), respectively. Median Sp for PVD and UE score ≥1 were 90% (86–93%) and 91% (86–93%), respectively. Higher scores in both tests were associated with impaired fertility, and UE scoring with a threshold of ≥1 had the highest test Se and Sp estimates although test Se was conditional on days in milk when the PBE occurred.     

Plasma assists titanium nitride and surface modified titanium nitride nanoparticles from titanium scraps for magnetic properties and supercapacitor applications

Plasma methods are efficient processing for metal recovery from metal scrap, bearing minerals, electronic waste, etc. In this work, pure titanium nitride nanoparticles (TiN NPs) were synthesized from titanium scraps by the thermal plasma arc discharge (TPAD) method. TPAD synthesized TiN NPs have a highly crystalline nature with cubic and spherical morphologies with average particle sizes of 30–100 nm. Further, prepared TiN NPs involving surface modification (SM) or etching processes were investigated by using the non-thermal DC glow discharge plasma technique with air atmosphere at different processing times. SM@TiN NPs have a comparatively low crystalline, which was confirmed from the powder X-ray diffraction technique. SM@TiN NPs have very interesting core shell morphologies, which are due to the surface interactions of ionized air molecules. TiN and SM@TiN NPs have room-temperature ferromagnetic properties with high saturation magnetization (Ms) up to 2.6 and 3.0 emu/g and very high coercivity (Hc) of 235.5 Oe, respectively. TiN and SM@TiN NPs have superior energy storage performance with an outstanding specific capacitance of 192.8 and 435.1 F/g at a current density of 2 A/g with pseudocapacitive behavior. These results reveal that TiN and SM@TiN NPs have highly promising electrodes for supercapacitor applications.     

Consolidation considering increasing soil column radius for dredged slurries improved by vacuum preloading method

Soil column is often investigated in the improvement of dredged slurries. Different from the smear zone, the soil column forms gradually and has extremely low permeability. This study presents an analytical solution for soil consolidation considering the increasing radius of the soil column and time-dependent discharge capacity. Based on the solution, the influence of the radius' increase on the consolidation behavior is found significant when the soil column has low permeability and large final radius, and the increase of formation time can lead to the increase of consolidation speed and final consolidation degree.     

火花放电原子发射光谱类型标准化校正方式的探讨

在国内,火花放电原子发射光谱分析广泛使用类型标准化进行方法校正。在国外,标准和文献中鲜见使用此方法的相关论述。类型标准化主要采用平移校正和转动校正两种方式,哪种方式更加合理也鲜见报道。国外设备类型标准化的默认设置优先采用转动校正方式,相关国内标准对最优校正方式的规定尚不明确,此默认设置的合理性有待探讨。实验选用低合金钢20CrNi2Mo、R407标准样品和不锈钢317L、0Cr18Ni9标准样品,引用国内相关标准,以正确度临界差为评判依据,模拟类型标准化样品和待测样品“十分接近”和“接近”两种情况下平移校正和转动校正的数据正确度。经数据统计分析,平移校正分析结果均满足要求,转动校正结果在“接近”情况下部分元素不满足要求。结合相关国家标准中元素含量范围和精密度数据进行分析,通过计算允许最大偏倚量并制作曲线图方式展开分析,得出如下结论:在满足文中类型标准化控制要点前提下,分析设置更适合于采用平移校正方式。     

Annealing temperature-dependent structural and electrical properties of (Ta2O5)1-x - (TiO2)x thin films,x ≤ 0.11

(Ta₂O₅)_1-x- (TiO₂)_x (TTO_x) thin films, with x = 0, 0.03, 0.06, 0.08, and 0.11, were deposited using magnetron direct current (DC) sputtering method onto the P/boron-silicon (1 0 0) substrates by varying areas of Tantalum and Titanium metallic targets, in oxygen environment at ambient temperature. The as-deposited thin films were annealed at temperatures ranging from 500 to 800 °C. Generally, the formation of the Ta₂O₅ structure was observed from the X-ray diffraction measurements of the annealed films. The capacitance of prepared metal– oxide– semiconductor (MOS) structures of Ag/TTO_x/p-Si was measured at 1 MHz. The dielectric constant of the deposited films was observed altering with varying composition and annealing temperature, showing the highest value 71, at 1 MHz, for the TTO_x films, x = 0.06, annealed at 700 °C. With increasing annealing temperature, from 700 to 800 °C, the leakage current density was observed, generally decreasing, from 10^?5 to 10^?8 A cm^?2, for the prepared compositions. Among the prepared compositions, films with x = 0.06, annealed at 800 °C, having the observed value of dielectric constant 48, at 1 MHz; and the leakage current density 2.7 × 10^?8 A cm^?2, at the electric field of 3.5 × 10⁵ V cm^?1, show preferred potential as a dielectric for high-density silicon memory devices.     

Weighted regularized extreme learning machine to model the discharge coefficient of side slots

In the current research, a modern learning machine algorithm named “Weighted Regularized Extreme Learning Machine (WRELM)" is implemented for the first time for the simulation of the coefficient of discharge of side slots. For this purpose, an effective variable on the coefficient of discharge of side slots is firstly introduced, then five distinctive WRELM models are produced by it for the estimation of the coefficient. In the next stage, a database is created for verification of WRELM results. it should be mentioned that 70% of the data are utilized for training the WRELM models, while the rest (i.e. 30%) for testing them. After that, the optimal number of hidden layer neurons as well as the best activation function of the WRELM algorithm are chosen. In addition, the best regularization parameter and also the weight function of the WRELM are achieved. By conducting a sensitivity analysis, the most effective variable for the simulation of the coefficient of discharge along with the WRELM superior model is introduced. The WRELM superior model estimates values of the coefficient of discharge with the maximum exactness and the highest correlation. For instance, the estimations of the correlation coefficient and scatter index for this model are computed to be 0.930 and 0.051, respectively. The sensitivity analysis shows that the ratio of the side slot crest height to its length and the Froude number should be considered as the most important input variables. A comparison between the WRELM with the ELM displays that the former works much better. Furthermore, an uncertainty analysis is executed for both models. Eventually, an equation is suggested for the estimation of the coefficient of discharge and a partial derivative sensitivity analysis is performed on it.     

基于混合模式快速电荷平衡的神经刺激器

设计实现了一种可用于脊髓神经刺激器的多通道大电流神经刺激器。提出将电极短接和插入短电流脉冲相结合的混合模式,在大电流下,能更加快速地实现电荷平衡。电路设计上,将ADC动态比较器的回踢噪声消除技术应用于神经刺激器,使得动态比较器在输入压差较小时能够输出正确的比较结果,从而将电极上残留电压保持在更安全的范围内。基于CSMC 0.25 μm BCD工艺进行设计与仿真,结果表明,在单向且最大刺激电流为4 mA、刺激脉宽为60 μs、刺激周期为750 μs的条件下,该15 V、16路神经刺激器能实现±50 mV安全电压的有源电荷平衡。     

瞬变电磁井间勘探的全空间几何因子

井间是剩余油的主要分布区域,为探测井间剩余油,提高采收率,提出了基于全空间几何因子的瞬变电磁井间勘探方法。在本井使用线圈发射、邻井使用线圈接收,根据瞬变电磁场理论,在阶跃信号的激励下发射线圈在地层中激发出沿圆周方向的闭合瞬变电场,该电场在导电地层中产生与地层电导率呈正比的涡流。由Doll地层环模型可知,地层中的涡流在空间任意点激发得到与地层电导率成正比的二次场响应信号(有用信号),并可表示为空间各点电导率的加权平均值,其权重即为井间瞬变电磁勘探的全空间几何因子;全空间几何因子集中分布在发射线圈和接收线圈附近,其它区域分布较少,在发射线圈和接收线圈两侧呈现不同的极性;对瞬变电磁响应与地层电导率、井间距和源距的变化规律研究可知,瞬变电磁井间勘探有用信号随着地层电导率的增大而增大,随着井间距的增加单调减小,在发射线圈和接收线圈处于同一深度时该响应信号幅度最大。     

浅谈不同给液方式在铜电解车间的应用

不同给液方式对铜电解过程中有重要的影响,不同的循环方式会影响槽内温度分布、电解液成分及阳极泥沉降等,因此,根据铜电解生产不同情况的需要,分析对比了多种给液方式在贵冶电解车间的应用,总结了这几种给液方式的优缺点和适用条件。